PLEASE READ THE MAIN INSTRUCTIONS BEFORE COMMENCING, THEN FOLLOW STEPS SHOWN IN THE DIAGRAM BELOW.

1. POSITION THE FRONT MOUNTING (B) IN THE AREA (A) BETWEEN THE EXHAUST MANIFOLD AND CRANKCASE.

2. POSITION THE REAR MOUNTING (H) UNDER THE GEARBOX AND FULLY LOCATE THE M8 TAPER PIN INTO THE RIGHT HAND CASING HOLE (G).

3. ADJUST THE MOUNTINGS TO THE DESIRED HEIGHT TO SUIT YOUR MACHINE AND FIRMLY TIGHTEN THE FOUR M8 BOLTS AT ADJUSTER SLOTS.

NOTE THE SIDE STAND 'C' CLAMP FOR THE DUCATI HAS TWO FIGURE OF '8' HOLES ALLOWING EXTRA INWARD TRAVEL TO COVER THE UNUSUALLY SMALL STAND FOOT POSITION THIS FULLY IN THE CAPTURE PLATE AND ALWAYS USE THE 'U' BOLT FOR ADDED SECURITY.