Lifting Ducati Bikes

When using Multi-Mounts to lift Ducati's you may choose to opt for our Ducati variant which uses alternative top elements for the front and rear lifting brackets; this enables you to support the front of the bike via the cylinder barrel as opposed to cradling the collector pipes, whilst lifting the rear of the bike direct off the gearbox casing.

Both the front and rear lifting brackets of our Multi-Mount system are made up of two parts; the lower of the two is essentially a box section which you slip onto the main lifting beam, the top half is specifically designed to suit the region of the bike being supported.

The Ducati front bracket uses our V-Twin top element that allows you to position it just under the exhaust manifold as it exits the cylinder barrel, thus the barrel takes the weight of the front portion of the machine.

You can purchase the top elements of these brackets separately and use them in conjunction with the standard Multi-Mount system (they are inter-changeable), or you can specify complete Ducati Multi-Mounts at the outset.  If you own more than one type of SuperBike (or you intend replacing your bike soon) we will be happy to help you find the best way forward.

 

DUCATI FITTING INSTRUCTIONS

PLEASE READ THE MAIN INSTRUCTIONS BEFORE COMMENCING, THEN FOLLOW STEPS SHOWN IN THE DIAGRAM BELOW.

1. POSITION THE FRONT MOUNTING (B) IN THE AREA (A) BETWEEN THE EXHAUST MANIFOLD AND CRANKCASE.

2. POSITION THE REAR MOUNTING (H) UNDER THE GEARBOX AND FULLY LOCATE THE M8 TAPER PIN INTO THE RIGHT HAND CASING HOLE (G).

3. ADJUST THE MOUNTINGS TO THE DESIRED HEIGHT TO SUIT YOUR MACHINE AND FIRMLY TIGHTEN THE FOUR M8 BOLTS AT ADJUSTER SLOTS.

NOTE THE SIDE STAND 'C' CLAMP FOR THE DUCATI HAS TWO FIGURE OF '8' HOLES ALLOWING EXTRA INWARD TRAVEL TO COVER THE UNUSUALLY SMALL STAND FOOT POSITION THIS FULLY IN THE CAPTURE PLATE AND ALWAYS USE THE 'U' BOLT FOR ADDED SECURITY.